Routine maintenance of the forklift

First, the cleaning forklift dirt, dirt and scale Egypt, the key parts are: fork frame and mast slide, generator and starter, battery electrode fork column, water tank, air filter. Second, check the fastening of the various parts, the focus is: fork support, lifting chain tensioning screws, wheel screws, wheel pin, brake, steering screw. Third, check the steering gear reliability, flexibility. Fourth, check the leakage, the focus is: the pipe joints, diesel tanks, fuel tanks, brake pumps, lifting cylinders, tilt cylinders, tanks, pumps, engine oil pan, torque converter, transmission, transaxle, Device, hydraulic steering gear, steering cylinder. Fifth, the tire pressure check: deficiencies should be added to the specified value, to confirm airtight. Check the tire ground and side surfaces for damage, the wheel is deformed. Six, brake fluid, water check: check whether the brake fluid within the scale, and check the brake line is mixed with air. When adding brake fluid, prevent dust and water from mixing. When adding water to the tank, use clean tap water. If antifreeze is used, add the same antifreeze. When the water temperature is higher than 70 ℃, do not open the water tank cover, open the cover, the pad of a thin cloth, do not bring glove screw tank cover .Seventh, the engine oil, hydraulic oil, electrolyte check: first pull out the oil ruler, Insert the head back and pull out to check if the oil level is between the two tick marks. The oil level in the work tank should be between two tick marks; too little oil will mix in the air and too much will escape from the cover. Battery electrolyte also need to be in between the upper and lower scale line, less than the top line to add distilled water. Eight brake pedal, micro pedal, clutch pedal, hand brake check: Depress the pedal to check whether there is abnormal slow Or jammed. Hand brake handle force should be less than 300N, confirm hand brake safe and reliable. Nine, belts, speakers, lights, meters, etc. Check: Check the tightness of the belt is in line with the provisions of no margin adjustment or crack, to be replaced; Speaker, lighting, instrumentation should be normal and effective. Ten, put the oil filter sediment. Forklift drivers usually pay more attention to forklifts, forklifts should also be done: early detection, early treatment, everything is so. This forklift longer life, but also save us a lot of things.