The role, classification and drive circuit design of digital tube drive circuit

Industrial Router Crystal 3.2*2.5mm 3225 26M (26.000MHZ) 12PF 10PPM 20PPM 30PPM

ESD electrostatic protection tube 5V two-way 0201

The diameter of the probe domestically produced P02-A2 needle nickel-plated needle is 0.68 spring needle

The role of the digital tube driver circuit:

The function of the digital tube driving circuit is mainly to control the LED digital tube (light emitting diode) circuit by using a single chip microcomputer to realize the dynamic display effect of the digital output of the digital tube LED screen.

Classification of digital tubes:

(1) Classified according to the number of digital pipe segments

The digital tube is a semiconductor light emitting device whose basic unit is a light emitting diode. It is divided into seven segments of digital tubes and eight segments of digital tubes according to the number of segments. The eight-segment digital tube has one more LED unit than the seven-segment digital tube (that is, one more decimal point display);

(2) According to the digital tube digital display classification

According to how many "8" can be displayed, it can be divided into 1, 2, 4, etc. digital tubes;

(3) Classification according to digital tube connection

According to the connection mode of the LED unit, it is divided into a common anode digital tube and a common cathode digital tube.

Gongyang Digital Tube and Gongyin Digital Tube:

Among them, the common digital tube refers to a digital tube that connects the anodes of all the light emitting diodes together to form a common anode (COM). The common anode digital tube should connect the common pole COM to +5V when applied. When the cathode of a field LED is low, the corresponding field will light up. When the cathode of a field is high, the corresponding field is not lit.

The common cathode digital tube refers to a digital tube that connects the cathodes of all the light emitting diodes together to form a common cathode (COM). When the common cathode digital tube is applied, the common pole COM should be connected to the ground line GND. When the anode of a field LED is high level, the corresponding field will be lit. When the anode of a field is low, the corresponding field is not lit.

Example of common anode digital tube drive circuit:

Parallel LED digital tube static display circuit (common yang)

Common Yin digital tube driver circuit example:

Serial LED digital tube dynamic scanning display circuit (total)

More common digital tube and common cathode digital tube driver circuit, please click the following link to browse:

The following provides a digital tube driving circuit design, which can realize the digital 0~9 control output of the LED digital tube.

working principle:

As shown in Figure 1, the circuit consists of a NAND gate 74LS00 and a digital tube driver chip 74LS247. The 10 buttons form the input circuit. After the NAND gate circuit is encoded, the digital tube driver chip is input, and the digital tube is driven to display the corresponding button number.

When designing the key encoding circuit, first write out the truth table, and the truth table can write the following formula:

A={I1 ·I3 ·I5 ·I7 · I9 } (in the braces, each factor is inverted and together are inverted) = I1+I3 +I5 +I7 +I9

B={I3 ·I4 ·I6 · I7} (in the braces, each factor is inverted, and then together are reversed) = I3+I4+I6+I7

C={I4 ·I5 ·I6 · I7} (in the braces, each factor is inverted, and then together are negated) = I4 +I5 +I6+I7

D={I8 · I9 } (in the braces, each factor is inverted, and then together are reversed) = I8+I9

In order to make the power supply voltage not exceed the voltage range of the digital tube, the power supply is connected in series with four diodes and then added to the digital tube. This saves components.

Circuit schematic

Component list