Electric forklift DC motor use matters needing attention
August 01, 2022
DC motor use of electric forklifts Haili electric forklift DC auxiliary motor, we need to pay attention to the following points in the use of:
The motors used in our company are specialized for battery-powered industrial electric vehicles, such as forklifts, vans, stackers, and other auxiliary motors, where the conditions of use need to meet the following points: the altitude does not exceed 1200 meters, and the low temperature is not lower than zero At 25 degrees, no condensation can form on the surface of the motor. The center position of the brush has been adjusted after the factory test. Users cannot dismantle and adjust the electric forklift after purchase.
1. Users must fully comply with the instructions issued by our company.
2, the motor must be kept dry, clean, ventilated, the temperature must not be low.
3. When the user checks the motor drying condition of the electric forklift, it must be powered off to avoid accidents.
4, with 250V megger to measure the motor cold insulation resistance, the following 45V motor is 0.5M Europe, 45V--110V motor is 1M Europe.
5, if you can not reach the drying requirements must be dried, put the room to dry or dry, the drying process must pay attention to the coil temperature, not too high, check the insulation resistance to ground.
6. Check if the armature is flexible.
7. Check if the motor's link is properly secured.
The brush should slide freely inside the box and the photo should be clean.
The coil insulation resistance should be checked regularly.
If it is found that the motor failure immediately stops working, the maximum voltage of the motor is 1.1 times the total nominal voltage of the series battery element.
Please keep the casing clean and brush the dirt away so as not to affect its heat dissipation. Check the steering gear, brushes, chainsaw and so on at least once every six months.
The above are the precautions for the use of the motor of our Haili electric forklift. Please follow the operating procedures.